We value your privacy

Our website uses cookies to enhance your experience. By continuing to use our website, you are agreeing to our use of cookies. Necessary cookies are always enabled. You can read more about our Cookie Policy in our Privacy policy

We value your privacy

FibreGlassDirect - Buy Fiberglass Supplies & Materials

Shopping Cart 0
£0.00

20kg Low Cost General Purpose Resin & Catalyst

In stock
SKU
K9901007x4
£103.34 £86.12

Synolite 1066-P-1 is a non-Lloyds approved general purpose pre-accelerated orthoplthalic polyester resin designed for non-critical applications. It is not for use in marine, food or potable water applications. It is a non-standard resin with no specified chemical resistance. The resin rapidly wets out glass mat and can be used in hand lay-up and spray manufacturing.
Contains:

  • 4 x 5kg Pack Low Cost General Purpose Resin
  • 4 x 100ml catalyst

Synolite 1066-P-1 is a non-Lloyds approved general purpose pre-accelerated orthoplthalic polyester resin designed for non-critical applications. It is not for use in marine, food or potable water applications. It is a non-standard resin with no specified chemical resistance. The resin rapidly wets out glass mat and can be used in hand lay-up and spray manufacturing.

Ask a Question
This depends on the temperature of your working conditions and how much catalyst has been incorporated into the mix. Warmer temperatures will reduce your curing time and colder temperatures will increase the length of cure.  Likewise, adding extra catalyst will speed up the curing process - often necessary for colder temperatures and reducing catalyst will reduce curing - again often necessary during warmer temperatures. We would recommend mixing no more than 1.5 - 2kg at a time. Once the resin and catalyst are mixed, the curing process will begin and you are working against the clock to get the resin applied - usually no more than 20 minutes. Only mix as much as you need.  Epoxy Resin is mixed on a ratio basis and should not be altered. Room temperature is the ideal scenario for curing. Each resin type will differ so we would always recommend referring to the MSDS and TDS available on each product listing before use.  Although some resins may be hard to the touch after 24 hours, some may not be fully cured for up to 3 days. Again, this information will be available on the product Technical Data Sheet... Read more
Brand Description
History Color sit amet, consectetur adipiscing elit. In gravida pellentesque ligula, vel eleifend turpis blandit vel. Nam quis lorem ut mi mattis ullamcorper ac quis dui. Vestibulum et scelerisque ante, eu sodales mi. Nunc tincidunt tempus varius. Integer ante dolor, suscipit non faucibus a, scelerisque vitae sapien.