Trims

The A type trim is a drip trim, fitted to the lowest edge of the roof usually where the rainwater flows into the gutter. Compatible with the B260 upstand trim.

DIMENSIONS

Girth: 200mm, Depth: 90mm

This trim is fitted to the roof edge to allow drainage into a gutter. The increased length of the gutter leg allows this trim to be used on warm roof specifications where insulation is applied under the boarding.

The A250 is compatible with the B300 trim and C1, C2 and C4 corners.

The AT195 External Fibreglass Roofing Trim is used when forming external corners on features such as steps or wall tops, it can be used horizontally or vertically. If an Internal Corner is needed, the AT195 Internal Trim is ideal.

Fitted to the roof edge, this trim prevents water run off. This trim is compatible with the A200 Drip Roofing Trim.

Dimensions

Girth: 260mm, Depth: 125mm, Length: 1.5 metres / 3 metres

The B300 Roof Trim for Fibreglass Roofing is fitted to the edge of the flat roof to prevent water run-off. The depth of this drip matches the A250 Drip Trim. This trim is also compatible with the C1, C2 and C4 corner trims. 

Length: 3m; Vertical cover: 100mm; Wall penetration: 35mm

Dark grey, non-adhesive finish to simulate the appearance of lead. Do not topcoat.

Used where flat roof butts against existing wall and creates a 45-degree angle to deflect rainwater from wall to roof. Can also be used for gutter lining. It will also provide expansion and perimeter ventilation and is compatible with C2 and C3 universal corners.

Dimensions: 

Girth: 260mm; Fillet: 135mm & 70mm; Upstand height: 120mm; Length: 1.5 metre / 3 metre  

The E280 Expansion Joint is normally used on fibreglass flat roofs which are 50 square metres and over. It can also be used to create rolls on any ridge details. It is compatible with C5 preformed closures. 

Used to simulate the appearance of raised rolled lead joints, also provides expansion. 

The C150 Simulated Lead Flashing Trim is has a 150mm vertical face and 35mm wall penetration. It is suitable as a replacement for traditional lead flashings. It is supplied with a dark grey, non-adhesive finish. Topcoat does not need to be applied to this trim. 

The B230 is fitted to the edge of the fibreglass roof to prevent water run-off. It is compatible with the A170 Fascia Trim and standard corner trims. 

Dimensions

• Girth: 230mm
• Depth: 105mm

Dimensions

• Girth: 170mm
• Depth: 65mm

75mm wide, 450gm Fibreglass mat bandage roll, ideal for the taping of roof board joints and trim joints.

The G180 Gulley Trim/Expansion Joint is generally used in fibreglass roofs over 50sqm for expansion purposes. It is also used for drainage. 

Dimensions

• Girth: 180mm
• Flanges: 30mm
• Depth: 15mm
• Trough width: 80mm

The AT195 Internal trim is used wherever the laminate needs to cover an area which continues perpendicular to another laminated surface. The AT195 Ext is supplied with a high-adhesion finish on its outer fascia and is mainly used for capping applications.