We value your privacy

Our website uses cookies to enhance your experience. By continuing to use our website, you are agreeing to our use of cookies. Necessary cookies are always enabled. You can read more about our Cookie Policy in our Privacy policy

We value your privacy

FibreGlassDirect - Buy Fiberglass Supplies & Materials

Shopping Cart 0
£0.00

40kg Lloyd's Approved General Purpose Resin & Catalyst

In stock
SKU
K9901004
£217.32 £181.10

Lloyds approved Polyester Resin with fast glass wet out and low exotherm characteristics suitable for marine use, boat repair and maintenance. The resin is also WRAS approved.

Contains:

  • 2 x 20kg Resin
  • 2 x 500ml catalyst

Norsodyne H 13212 is a pre-accelerated, thixotropic, low styrene emission Lloyds approved Polyester Resin with fast glass wet out and low exotherm characteristics. Being Lloyds approved it is suitable for marine use, boat repair and maintenance. The resin is also WRAS approved for use in potable water applications and used extensively in water tank construction and water treatment applications.

How to mix resin and catalyst

A brief guide on how to mix resin and catalyst

Ask a Question
We would recommend our Lloyd's Approved Resin, this would be a good general purpose resin suitable for this purpose.
This depends on the temperature of your working conditions and how much catalyst has been incorporated into the mix. Warmer temperatures will reduce your curing time and colder temperatures will increase the length of cure.  Likewise, adding extra catalyst will speed up the curing process - often necessary for colder temperatures and reducing catalyst will reduce curing - again often necessary during warmer temperatures. We would recommend mixing no more than 1.5 - 2kg at a time. Once the resin and catalyst are mixed, the curing process will begin and you are working against the clock to get the resin applied - usually no more than 20 minutes. Only mix as much as you need.  Epoxy Resin is mixed on a ratio basis and should not be altered. Room temperature is the ideal scenario for curing. Each resin type will differ so we would always recommend referring to the MSDS and TDS available on each product listing before use.  Although some resins may be hard to the touch after 24 hours, some may not be fully cured for up to 3 days. Again, this information will be available on the product Technical Data Sheet... Read more
Brand Description
History Color sit amet, consectetur adipiscing elit. In gravida pellentesque ligula, vel eleifend turpis blandit vel. Nam quis lorem ut mi mattis ullamcorper ac quis dui. Vestibulum et scelerisque ante, eu sodales mi. Nunc tincidunt tempus varius. Integer ante dolor, suscipit non faucibus a, scelerisque vitae sapien.