- This over-sized soffit trim is used to encapsulate the edge profile of a concrete or similar construction deck. A wooden support batten is nailed to the wall underneath the roof structure.
The S500 trim is nailed to the roof at 300mm centres and then the underside attached by nails to the supporting batten.
The edges of the S500 soffit trim, including any nail heads, should be sealed with Fibreglass bandage and resin before application of the main roofing laminate.
The laminate should not extend onto the fascia of the trim.
Roofing Trim FAQ'sA. The following trims are compatible with each other
A. A drip trim is placed at the lowest edge of the roof and is used to allow the water to runoff into a gutter. A raised edge trim is used to prevent the water runoff.A. Roof trims should be measured and cut to size with a snips (to reduce dust). A dap of roofing adhesive should be applied to the batons to prevent rattling in the wind. Roof trims should then be either stapled with s/s staples of nailed using 15mm clout nails into place every 120-150mm. Where two trims have to be joined together, ensure an overlap of 50mm and apply roofing adhesive to seal.
- A200 is a fascia trim for allowing drainage into a gutter. Compatible with C1 C2 and C4 corner trims
- B260 is a raised edge trim which prevents water runoff. Compatible with C1 C2 and C4 corner trims
- A200 and the B260 are compatible with each other
- A250 and B300 - A250 is a fascia trim for allowing drainage into a gutter & the B300 is a raised edge trim which prevents water runoff
A. It is recommended that 15mm galvanised clout nail are used or s/s staples that will sit flush with the roof.A. We recommend the following steps to fix a crack in a GRP Trim
A. Whilst we would recommend GRP Trims with a fibreglass roof (the fibreglass will bond better). If you decide to use lead or metal trims, ensure the lead or metal is clean and free from contaminates. Use G4 sealer when overlapping with the fibreglass.
- Sand an area of about 50mm around the crack using rough grit sandpaper to create a key. Clean down with acetone.
- Cut a piece of 450g chopped strand mat the same size as the area sanded. Cut a second piece of 450g chopped strand mat slightly smaller.
- Mix resin and catalyst. Brush on the resin to the area and apply the larger piece of glass. Applied more resin until the glass is fully wetted out. Apply the second layer of glass and wet out with resin using a brush. Allow to cure.
- Once cured give the area a light sanding to remove any glass sticking up.
- Mix topcoat with catalyst and apply to the area with brush.
There are no documents for this product.