• A200 is a fascia trim for allowing drainage into a gutter. Compatible with C1 C2 and C4 corner trims
• B260 is a raised edge trim which prevents water runoff. Compatible with C1 C2 and C4 corner trims
• A200 and the B260 are compatible with each other
• A250 and B300 - A250 is a fascia trim for allowing drainage into a gutter & the B300 is a raised edge trim which prevents water runoff

Read more

Roof trims should be measured and cut to size with a 'snips' (to reduce dust). A dab of roofing adhesive should be applied to the batons to prevent rattling in the wind. Roof trims should then be either stapled with s/s staples of nailed using 15mm clout nails into place every 120-150mm. Where two trims have to be joined together, ensure an overlap of 50mm and apply roofing adhesive to seal.

It is recommended that 15mm galvanised clout nail is used or s/s staples that will sit flush with the roof.

Sand an area of about 50mm around the crack using rough grit sandpaper to create a key. Clean down with acetone. Cut a piece of 450g chopped strand mat the same size as the area sanded. Cut a second piece of 450g chopped strand mat slightly smaller. Mix resin and catalyst. Brush on the resin to the area and apply the larger piece of glass. Applied more resin until the glass is fully wetted out. Apply the second layer of glass and wet out with resin using a brush. Allow the resin to cure. Once cured give the area a light sanding to remove any glass sticking up. Mix topcoat with catalyst and apply to the area with a... Read more

Whilst we would recommend GRP Trims with a fibreglass roof (the fibreglass will bond better). If you decide to use lead or metal trims, ensure the lead or metal is clean and free from contaminants. Use G4 sealer when overlapping with the fibreglass.