A250 Drip Roof Trim
This trim is fitted to the roof edge to allow drainage into a gutter. The increased length of the gutter leg allows this trim to be used on warm roof specifications where insulation is applied under the boarding.
The A250 is compatible with the B300 trim and C1, C2 and C4 corners.
This trim is fitted to the roof edge to allow drainage into a gutter. The increased length of the gutter leg allows this trim to be used on warm roof specifications where insulation is applied under the boarding.
The A250 is compatible with the B300 trim and C1, C2 and C4 corners.
- A200 is a fascia trim for allowing drainage into a gutter. Compatible with C1 C2 and C4 corner trims
- B260 is a raised edge trim which prevents water runoff. Compatible with C1 C2 and C4 corner trims
- A200 and the B260 are compatible with each other
- A250 and B300 - A250 is a fascia trim for allowing drainage into a gutter & the B300 is a raised edge trim which prevents water runoff
A drip trim is placed at the lowest edge of the roof and is used to allow the water to runoff into a gutter. A raised edge trim is used to prevent the water runoff.
Roof trims should be measured and cut to size with a 'snips' (to reduce dust). A dab of roofing adhesive should be applied to the batons to prevent rattling in the wind. Roof trims should then be either stapled with s/s staples of nailed using 15mm clout nails into place every 120-150mm. Where two trims have to be joined together, ensure an overlap of 50mm and apply roofing adhesive to seal.
It is recommended that 15mm galvanised clout nail is used or s/s staples that will sit flush with the roof.
Whilst we would recommend GRP Trims with a fibreglass roof (the fibreglass will bond better). If you decide to use lead or metal trims, ensure the lead or metal is clean and free from contaminants. Use G4 sealer when overlapping with the fibreglass.