1. See Detail

B300 Raised Edge Roofing Trim

SKU
conf_b300_raised_edge_roofing_trim
In stock
As low as £9.54 £7.95
Quick Overview

The B300 Roof Trim for Fibreglass Roofing is fitted to the edge of the flat roof to prevent water run-off. The depth of this drip matches the A250 Drip Trim. This trim is also compatible with the C1, C2 and C4 corner trims. 

The B300 Roof Trim for Fibreglass Roofing is fitted to the edge of the flat roof to prevent water run-off. The depth of this drip matches the A250 Drip Trim. This trim is also compatible with the C1, C2 and C4 corner trims. 

Ask a Question
The following trims are compatible with each other
  • A200 is a fascia trim for allowing drainage into a gutter. Compatible with C1 C2 and C4 corner trims
  • B260 is a raised edge trim which prevents water runoff. Compatible with C1 C2 and C4 corner trims
  • A200 and the B260 are compatible with each other
  • A250 and B300 - A250 is a fascia trim for allowing drainage into a gutter & the B300 is a raised edge trim which prevents water... Read more
    Published in: Roofing Trims

A drip trim is placed at the lowest edge of the roof and is used to allow the water to runoff into a gutter. A raised edge trim is used to prevent the water runoff.

Published in: Roofing Trims

Roof trims should be measured and cut to size with a 'snips' (to reduce dust). A dab of roofing adhesive should be applied to the batons to prevent rattling in the wind. Roof trims should then be either stapled with s/s staples of nailed using 15mm clout nails into place every 120-150mm. Where two trims have to be joined together, ensure an overlap of 50mm and apply roofing adhesive to seal.

Published in: Roofing Trims

It is recommended that 15mm galvanised clout nail is used or s/s staples that will sit flush with the roof.

Published in: Roofing Trims

Fixing a crack in a GRP Roof Trim

  • Sand an area of about 50mm around the crack using rough grit sandpaper to create a key. Clean down with acetone.
  • Cut a piece of 450g chopped strand mat the same size as the area sanded. Cut a second piece of 450g chopped strand mat slightly smaller.
  • Mix resin and catalyst. Brush on the resin to the area and apply the larger piece of glass. Applied more resin until the glass is fully wetted out. Apply the second layer of... Read more
    Published in: Roofing Trims

Whilst we would recommend GRP Trims with a fibreglass roof (the fibreglass will bond better). If you decide to use lead or metal trims, ensure the lead or metal is clean and free from contaminants. Use G4 sealer when overlapping with the fibreglass.

Published in: Roofing Trims